尾门控制系统

Key features

• AEC-Q100 qualified
• Output current: 15 A
• 3 V CMOS-compatible inputs
• Undervoltage shutdown
• Overvoltage clamp
• Thermal shutdown
• Cross-conduction protection
• Current and power limitation
• Very low standby power consumption
• Protection against loss of ground and loss of VCC
• PWM operation up to 20 kHz
• MultiSense diagnostic functions
  • Analog motor current feedback
  • Output short to ground detection
  • Thermal shutdown indication
  • OFF-state open-load detection
  • Output short to V_CC detection
• Output protected against short to ground and short to V_CC
• Standby Mode
• Half Bridge Operation
• Package: ECOPACK^®

显示较多内容

Key features

• AEC-Q100 qualified
• Output current: 15 A
• 3 V CMOS-compatible inputs
• Undervoltage shutdown
• Overvoltage clamp
• Thermal shutdown
• Cross-conduction protection
• Current and power limitation
• Very low standby power consumption
• Protection against loss of ground and loss of VCC
• PWM operation up to 20 kHz
• CS diagnostic functions
  • Analog motor current feedback
  • Output short to ground detection
  • Thermal shutdown indication
  • OFF-state open-load detection
  • Output short to V_CC detection
• Output protected against short to ground and short to V_CC
• Standby Mode
• Half Bridge Operation
• Package: ECOPACK^®

显示较多内容

Key features

• Simple single IC application board dedicated for VNH7100AS
• Provides electrical connectivity and thermal heat-sinking for easy prototyping

显示较多内容

Key features

• Simple single IC application board dedicated for VNH7070AS
• Provides electrical connectivity and thermal heat-sinking for easy prototyping

显示较多内容

Key features

• Simple single IC application board dedicated for VNH7040AY
• Provides electrical connectivity and thermal heat-sinking for easy prototyping

显示较多内容

Key features

• Board size 100 x 55 mm
• Two extension headers (2 x 36 pin - 100 mil) for quick connection to SPC560B-DIS discovery board
• Extension headers for quick connection of M0-7 easy board
• Extension headers for quick connection of H-Bridge easy board
• Controllable by dedicated GUI for HSD or for H-Bridge available on www.st.com
• Free ready to run application firmware for HSD or for H-Bridge available on www.st.com, to support quick evaluation and development

显示较多内容

Key features

• SPC560B54L5 32-bit 48 MHz e200z0h CPU, 32-bit Power Architecture® Technology CPU, 768 kB Code Flash in an LQFP144 package.
• On-board USB-JTAG PLS debugger and HW selection mode to use stand-alone JTAG debuggers.
• Board power supply: through external +12 V PSU or from the USB bus (5 V supply voltage).
• Seven LEDs: D6 for 5 V power on,D2 for Reset, D101, D102, D103 for PLS debugger section, D7 and D8 for PC3 and PC2 outputs
• Two push buttons (reset and user)
• A potentiometers for ADC input (user)
• Two extension headers (2 x 36 pin - 100 mil) for all LQFP144 pins and for quick connection to prototyping boards, additional modules and easy probing.
• JTAG interface (2 x 7 male 100mil connector)
• USB port (mini -B)
• 16 MHz crystal
• Specification:
  • Board size 100 x 65 mm
  • MCU: SPC560B54L5 - LQFP144
  • 2 extension headers 2 x 36 pin - 100 mil
  • DC connector (+12 V input)
  • Mini USB - B
  • JTAG 2 x 7 - 100 mil connector

显示较多内容

Key features

• Complete Graphical User Interface (GUI) for SPC5VH-ADIS adapter board.

显示较多内容